The Audio Settings Window
ADR Master has some very sophisticated audio features that will help you in your every-day workflow. When dropping a movie onto the timeline, ADR Master will automatically create audio tracks and regions for all audio tracks the movie contains. But it doesn't just play them back, you can also route every single track to your desired output destination. This article will discuss ADR Master's audio settings window which contains several related settings and is also the place for managing audio output busses.
Here you see the audio settings window. It can be displayed by going to the Window menu and selecting "Audio Settings" or by using the Shortcut Shift+A. The window is separated into two sections: the settings section at the top and the actual routing section at the bottom.
- Output device
ADR Master will scan your system for all available audio devices when it starts. These devices will be listed here and you can pick the one you want to use for audio output here. ADR Master will store and restore all output busses and their routing using the matrix below on a per-device basis.
- Sample Rate
Pick the sample rate you want ADR Master to use. If you're running your DAW on the same machine, please make sure that this is set to the same sample rate your DAW is set to. If the machine is running only ADR Master, typically 48kHz is the best setting to use.
- Beep Out
By default, ADR Master plays audio beeps during streamer events. You can pick the output ADR Master uses for these beeps here.
- Beep Level
Select the output level of the audio beeps here.
- Beep Pitch
ADR Master's audio beeps are simple sine waves. You can select your preferred pitch here.
- Center remaining channel if one stereo channel is muted
ADR Master allows for individual muting of the left and right audio channels of stereo tracks. If one channel is muted by right-clicking the mute button, ADR Master will center the remaining channel if this checkbox is ticked.
Every output bus you create in the routing matrix will be selectable as an output destination for audio tracks in the track view of the main window. If the audio track's channel count doesn't match the output bus' channel count, ADR Master will up- or downmix the audio content automatically.